HP 7000 dl Router Series Guida Utente Scaricare il pdf (Pagina 816)

100

101

SROS Command Line Interface Reference Guide HDLC Command Set

bandwidth <value>

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.

This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Enter bandwidth in kbps.

Default Values

To view default values use the show interfaces command.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to

be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the HDLC interface to 10 Mbps:

(config)#interface hdlc 1

(config-hdlc 1)#bandwidth 10000

1 2 ... 811 812 813 814 815 816 817 818 819 820 821 ... 940 941

Commenti su questo manuale

Nessun commento

HP 7000 dl Router Series Guida Utente Pagina 816

Commenti su questo manuale

Prodotti e manuali riguardandi Networking HP 7000 dl Router Series