HP 7000 dl Router Series Guida Utente Scaricare il pdf (Pagina 809)

100

101

Command Reference Guide Tunnel Configuration Command Set

tunnel source [<ip address> | <interface>]

Use the tunnel source command to specify the IP address or name of a physical interface to use as the

source address for all packets transmitted on this interface. Use the no form of this command to clear the

tunnel source address.

Syntax Description

<ip address> Specifies the IP address in dotted decimal notation to use as the source address

for all packets transmitted on this interface (for example: 192.22.73.101).

<interface> Specifies the interface (in the format type <slot/port>) that contains the IP address

to use as the source address for all packets transmitted on this interface.

Default Values

By default, a tunnel source is not defined.

Command Modes

(config-tunnel x)# Tunnel Interface Configuration Mode

Functional Notes

Until a tunnel interface has a source IP address defined and the physical interface used as the source is

operational, the tunnel is not operational.

The tunnel source IP address will be the value put into the source field of the outer IP header after GRE

encapsulation of the original packet.

1 2 ... 804 805 806 807 808 809 810 811 812 813 814 ... 940 941

Commenti su questo manuale

Nessun commento

HP 7000 dl Router Series Guida Utente Pagina 809

Commenti su questo manuale

Prodotti e manuali riguardandi Networking HP 7000 dl Router Series