Hp StorageWorks 1510i Modular Smart Array Manuale Utente Scaricare il pdf (Pagina 22)

Conﬁguring Access Controls for LUN access

NOTE:

The steps in this section assume that you already have a basic iSCSI setup conﬁgured.

1. Use the set acl command to enable Access Controls on the target:

CLI> set acl target1 on

Access Controls Enabled

on Target target1

2. Decide whether to grant the initiator access to all LUNs on the target, or to a speciﬁcLUN,and

then do one of the following:

To grant the initiator access to all LUNs on the target, use the add acl_entry command:

CLI> add acl_entry initiator1 target=target1

Allowed access to all LUNs

on Target target1

by Initiator initiator1

To grant the initiator access to a speciﬁcLUN,usetheadd acl_entry command:

CLI> add acl_entry initiator1 lun=lun1t1

Allowed Initiator initiator1

access to LUN lun1t1

NOTE:

If more LUNs are added to the target, repeat the add acl_entry command as required to

include them.

Enabling iSNS

discovery of the iSCSI target

NOTE:

The steps in this section assume that you already have a basic iSCSI setup conﬁgured.

To set up iSNS, you must ﬁrst choose the method of discovering iSNS servers. Next, you must enable

iSNS on the iSCSI target.

• To use DHCP discovery of iSNS servers:

a. Bydefault,theMSA1510iusesDHCPtodiscoveriSNSservers.

b. Use the set discovery command to enable iSNS discovery on the iSCSI target.

CLI> set discovery target1 isns=enable

iSNS enabled

• To use SLP discovery of iSNS servers:

a. Use the set isns command to change the iSNS server discovery mode:

CLI> set isns server_discovery=slp

iSNS parameters set.

b. Use the set discovery command to enable iSNS discovery on the iSCSI target.

CLI> set discovery target1 isns=enable

Initial conﬁguration sequence

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 153 154

Nessun commento

Hp StorageWorks 1510i Modular Smart Array Manuale Utente Pagina 22