HP 10TB Guida Utente Scaricare il pdf (Pagina 20)

“Configure the EMU and iLO management processors” (page 20) describes how you can directly

connect a laptop or other local system to reconfigure these addresses.

Power on the storage system

1. Power on disk enclosures, if any.

2. Power on the storage system by pushing the power button on the back of the chassis.

Once the storage system power is on, power on the server blades if they do not automatically

power on.

NOTE: The disk enclosures will complete the startup process before the server blades will

automatically power on. The boot process may take 60 seconds or more. The blades can be

manually powered on after 60 seconds if they do not turn on automatically.

Configure the EMU and iLO management processors

Before configuring the management processors, verify the following:

• You have determined whether the network ports on the server are to use DHCP or static

addresses. If the network ports are to use static addresses, you must provide the addresses.

• For this step, the EMU port should not be connected to a switch. You can connect the EMU

port to a switch after the EMU and iLO NICs are configured.

Configure the EMU and iLO management processors for both servers as follows:

1. Connect a system (the configuration system) in the environment or a laptop to the EMU port

(Figure 14 (page 20)). You can use either a crossover or a regular Ethernet cable.

Figure 14 EMU NIC port connection

2. Configure the networking properties for the local system:

a. Open Control Panel, select Network Sharing Center or Network Connections, and navigate

to Local Area Connections.

b. Select Properties→Internet Protocol, and then select Properties.

c. If Use the following IP address: is selected, record values for the following items and

restore them after completing the EMU and iLO setup:

• IP address

• Subnet mask

• Default gateway

20 Installing the storage system

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 180 181

Commenti su questo manuale

Nessun commento

Cda CI330 Specifiche (28 pagine)

Marchio: Cda | Categoria: Washing machines | Dimensione: 0.80 MB |

Indice

ACCESSORIES

UNPACKING AND

UNBLOCKING THE

WASHING MACHINE

DRAINAGE

PRE-CLEANING

PREPARING

GARMENTS FOR

USING DETERGENT AND ADDITIVES

SELECTING THE WASH PROGRAMME

Programme

Max load

SPIN SPEED SELECTION

DELAY TIME SELECTION AND

ADDITIONAL FUNCTIONS

STARTING UP

LOCK FUNCTION

WASH PROGRAMME PHASES

AND POWER CUTS

Important Important

AND THE OUTSIDE

Important

ELECTRONIC APPLIANCES

04/07 LJ6A030Q9

Più prodotti e manuali per Lavatrici CDA

Modelli	Tipo di Documento
CI230WH	Specifiche CDA CI230SI washing machine, 28 pagine
CI240WH	Specifiche CDA CI240WH washing machine, 24 pagine
CI370	Manuale delle Istruzioni CDA CI370 washing machine, 21 pagine
CI340	Specifiche CDA CI340 washing machine, 24 pagine
ci925	Specifiche CDA ci925 Specifications, 36 pagine
C1370	Manuale Utente UL TEST REPORT AND PROCEDURE [en] , 173 pagine
3Z9	Manuale Utente 3Z9 Extractors, 12 pagine
CI394	Specifiche CDA CI394 Specifications, 36 pagine
CI340	Informazioni Techniche CDA CI340 Technical information, 65 pagine
CI240	Specifiche CDA CI240 Specifications, 24 pagine
ci261	Specifiche CDA ci261 Specifications, 74 pagine