HP SP400 Manuale Utente Scaricare il pdf (Pagina 18)

Use the HP sp400 Series Configuration Software

Imager tab

The Imager tab allows you to configure factors that affect the operation of the All-in-One imager module.

The All-in-One uses the Hand Held Products 5X80 imager module.

For additional information about configuring the imager, see the HandHeld Products 5X80 User’s Guide

available for download at

www.handheld.com.

• Initialization String: A string of commands that are sent to the imager when the All-in-One is

turned on.

• Termination String: A string of characters that are added to the end of the scanned string. To

enter non-ASCII characters, use a forward slash followed by two hex digits. A single forward slash

may be entered as //.

• Imager Pre-Trigger: Selecting the Pre-Trigger check box causes the imager to enter the triggered

state immediately after a scan is complete.

• Barcode Read Pre-presentation Timeout (ms): The number of milliseconds the imager waits to

scan a bar code before it exits the triggered state.

NOTE: The Barcode Read Pre-presentation Timeout (ms) box is only activated when the Pre-

Trigger check box is selected.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Nessun commento

HP SP400 Manuale Utente Pagina 18