HP Integrity NonStop H-Series Guida Utente Scaricare il pdf (Pagina 297)

HP NonStop Shadowbase Command Definitions

Queue Manager Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

288

Initial Changed

Version Version Values Default Value Specifications Alter

4.090 None Valid CPU number No

Specifies the number of the CPU to be used as a backup for the Queue

Manager (which means the Queue Manager will run as a persistent

process). The CPU for the value entered must exist on the system. If the

AUD object AUTORESTART parameter is set to ON and the Queue

Manager fails due to a CPU failure, AUDMON will restart the Queue

Manager in the BACKUPCPU.

The default is no value assigned, meaning the Queue Manager does not

run as a persistent process (if its primary CPU fails, it will not be restarted

in another CPU). Note that this parameter is ignored if the CPULIST

parameter is specified.

CHKPTWARNRATE number_of_seconds

Initial Changed

Version Version Values Default Minimum Maximum Alter

4.090 900 0 32767 Yes

This defines the time that the Queue Manager is to wait before outputting

an EMS message to indicate that the Queue Manager’s restart position for

the Consumer is lagging behind. The valid range is 0 through 32767

seconds. The default is 900 (15 minutes). If the Queue Manager lags

behind and an EMS message is issued and then it catches back up and

then lags behind again shortly thereafter, it won't issue another behind

EMS until CHKPTWARNRATE time has passed by.

CHKPTWARNTDIFF number_of_seconds

Initial Changed

Version Version Values Default Minimum Maximum Alter

4.090 8100 0 disable 32767 Yes

This is the lag time used by the Queue Manager to determine if the restart

position is lagging behind the current audit trail read position. The restart

position is determined to be lagging behind if the difference between the

time of last read audit trail record and the time of the current audit trail

restart position is equal to or greater than CHKPTWARNTDIFF. Setting

the parameter to 0 will disable the check.

Note: Long-running transactions could result in EMS messages being

issued if the CHKPTWARNTDIFF is set lower than the time it takes

for the transaction to complete.

COLLNAME coll_name

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 345 346

Nessun commento

HP Integrity NonStop H-Series Guida Utente Pagina 297