HP Access Control Guida di Avvio Rapido Scaricare il pdf (Pagina 67)

5.12 Configure XT devices

Prerequisites:

●

Agent and Secure Pull Print Express must be installed on the server.

●

Make sure the XT device is connected to a printer and to the network.

●

If your server has a firewall, make sure TCP 2000 is open to send configuration files.

●

If your server has a firewall, make sure UDP 11000 port is open for device discovery.

●

Make sure the IRM authentication method is set to Card Only.

●

Make sure the IRM Proximity Reader settings and Card settings are correct. Also, make sure Card ID

masking is enabled.

NOTE: After the card type configuration changes, the XT device must be rebooted or power cycled. To

power cycle the XT device, unplug the power cord from the device and then re-plug the power cord.

Follow the steps below:

1. Select the XT device from the device list, then click Configure.

2. In the Configure window, select Pull printing. Click OK.

The device reboots and then beeps five times, indicating the device is configured.

5.12.1 Pull print using XT card readers

Prerequisites:

●

The XT device is connected to a printer and the network.

●

The XT device is configured.

●

Cards are registered to users.

Follow the steps below:

1. Present your registered card at the XT card reader. The XT device identifies the registered card,

authenticates the user, and locates your stored jobs in the spool folder. All of your stored jobs are then

pulled from the spool folder, printed, and then deleted.

2. Collect your printed documents.

Section 5.12 Configure XT devices 59

1 2 ... 62 63 64 65 66 67 68 69 70 71

Nessun commento

HP Access Control Guida di Avvio Rapido Pagina 67