
System Technical Specifications
c04111527 — DA – 14262 Worldwide — Version 42 — June 25, 2014
Slot 3:
PCI Express Gen2 x8(4)* with open-ended connector**
Full-height, Full-length (with extender)
Slot 4:
PCI Express Gen3 x8 with open-ended connector**
Full-height, Full-length (with extender)
Slot 5:
PCI Express Gen3 x16
Full-height, Full-length (with extender)
* x<number> = number of lanes or size of the physical/mechanical connector.
(number) = number of lanes supported electrically. Typically communicated as x# mechanical,
x(#)electrical.
** open-ended connector allow a greater bandwidth (e.g. x16) card to be installed physically into a lower
bandwidth connector/slot.
Slot 6:
PCI 32bit/33MHz
Full-height, Full-length (with extender)
Supported Drive
Interfaces
Integrated 10-channel SATA interface (2@6Gb/s, 8@3Gb/s).
Supports RAID 0, 1, 5, 10 and NCQ. Factory integrated RAID is
Microsoft Windows only.
Requires Optional PCIe card
RAID 0, RAID 1*, RAID 5, RAID 10
Supports one RAID array with 2-4 drives
RAID 0 configuration - striped array (supported and configure to order)
RAID 1 configuration - mirrored array (supported and configure to order)
RAID 5 parity striping (supported but not configure to order)
RAID 10 striped and mirrored array
*HW RAID functionality not supported by Linux. Use SW RAID functionality provided in the Red Hat
Operating system instead.
Integrated Intel 82579 and 82574 Controllers.
Memory Integrated 48KB receive buffer and 8KB transmit buffer
Data rates supported 10/100/1000 Mb/s
Compliance IEEE 802.3, 802.3AB and 802.3u compliant, 802.3x flow control
Bus architecture PCIe 1.0a
Data path width X1
Data path speed 2.5Gbit per sec per direction transfer rate
Data transfer mode Bus-master DMA
Power requirement 1.0 watts @ +3.3V AUX supply
Boot ROM support Yes
Network transfer rate 10BASE-T (half-duplex) 10 Mb/s
10BASE-T (full-duplex) 20 Mb/s
100BASE-TX (half-duplex) 100 Mb/s
Commenti su questo manuale