HP Z600 Specifiche Scaricare il pdf (Pagina 152)

CPU heatsink

This workstation offers a mainstream heatsink designed for CPUs less than or equal to 95W. It uses an

80mm fan.

This section describes how to remove and install a CPU heatsink.

Removing the CPU heatsink

1. Power down the workstation (see Predisassembly procedures on page 73).

2. Disconnect power from the workstation (see

Predisassembly procedures on page 73).

3. Remove the side access panel (see

Removing the side access panel on page 75).

4. Remove the memory fan (see

Removing the memory fan on page 122).

5. Slowly and evenly loosen one pair of diagonally opposite screws

from the CPU until the screw

shanks disengage from the system board, and then loosen the remaining pair

as shown in the

following figure.

CAUTION: Do not fully loosen one screw, and then move on to the next. Instead, loosen all

screws a little at a time, ensuring that the CPU remains level.

Figure 5-82 Loosening heatsink screws in sequence

140 Chapter 5 Replacing components ENWW

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 237 238

Nessun commento

HP Z600 Specifiche Pagina 152