HP Z600 Specifiche Scaricare il pdf (Pagina 104)

Installing a filler tray

1. Disconnect power from the workstation (see Predisassembly procedures on page 73).

2. Remove the side access panel (see

Removing the side access panel on page 75).

3. Lift and hold the drive release latch at the green touch point

while sliding the filler tray into the

bay

. When the front of the filler tray is near its final position, release the latch, but continue to

slide the filler tray inward until the latch closes and engages the filler tray.

TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and

align both devices to get the release latch to close and engage both devices.

While the tray is partially inserted, replace excess power cables in the tray for storage.

Figure 5-21 Installing a filler tray

TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and

align both devices to get the release latch to close and engage both devices.

92 Chapter 5 Replacing components ENWW

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 237 238

Nessun commento

HP Z600 Specifiche Pagina 104