HP Smart Tank Wireless 457 Manuale Utente Pagina 1

Start here

104Load paper Pull out input tray. Load plain white paper and adjust guide. Pull out output tray and extender.

113Press (Resume) for 3 seconds. Wait for alignment page to print when blinking “P” becomes “A”.Place alignment page on scanner glass.Press (Color

125123.hp.com123.hp.com123.hp.com123.hp.com123.hp.comComplete setup at 123.hp.com Enter 123.hp.com in a web browser on your computer or mobile device

13Always rell ink before it falls below lower line.Fill ink to upper line. Some ink might be left in the bottles.Product service or repairs required

14After setup, do not open the blue latch unless installing new printheads or moving printer outside home or oice.Keep latch closed

15Short Distance: If you are moving the printer within your home or oice, keep blue latch closed, and keep printer level.Long Distance: If you are mo

16Printed in English© Copyright 2018 HP Development Company, L.P.Z4B56-90037*Z4B56-90037**Z4B56-90037* Windows is either a registered trademark or tra

21Remove black bottle cap, remove seal. Replace cap, ip lid open.Fill ink tanks Open ink tank lid. Remove plug from black tank.

3Repeat steps for each color. Close lid. Save remaining black ink for relling.Hold bottle on tank nozzle. Fill ink to line. Replace plug and press fi

42Unpack and power on Remove packing material, tape, and two cardboard restraints.

5Plug in power cord and turn on printer. Connect USB cable only when prompted during software installation.

6Press down on blue latch to open.Wait for print carriage to move to center and stop. Turn orange handle.

7Remove and discard orange plastic piece. Handle carefully to avoid ink stains.

83Install printheads Remove plugs from tops of printheads, then remove tape from contacts using pull tabs.Slide in printheads until they snap. Firmly

9IMPORTANT! Keep blue latch closed after printhead installation.Close printhead access door, then close front door.