HP Netserver 5971-0821 Manuale Utente Scaricare il pdf (Pagina 79)

b Check the host bus adapter BIOS messages to verify that all your installed SCSI

devices are listed.

If some or all of your installed SCSI devices do not appear at this time, your

SCSI cables may be loose, or the SCSI device setup may not be complete. If so,

go back and correct any problem before proceeding.

c Wait for UNIX to boot with the new kernel.

See “Troubleshooting” on page 76 if the system crashes or if “panic” (UNIX

error) messages are displayed at boot time.

The adl60 driver for your HP Ultra3 SCSI host bus adapter should now be

ready for use.

Using SCO OpenServer and the Host Adapter

This section contains useful information on using SCO OpenServer and your

host bus adapter.

Using Multiple Host Adapters

If you are adding an additional HP Ultra3 SCSI host bus adapter to a system

with an Ultra3 SCSI host bus adapter already installed, follow the instructions

in the SCO OpenServer documentation for adding devices using the mkdev

command. When the system asks for the host adapter prefix, type ad160 and

press Enter.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 119 120

Nessun commento

HP Netserver 5971-0821 Manuale Utente Pagina 79