HP Digital NetRider Manuale Utente Scaricare il pdf (Pagina 38)

100

101

Commands to Display and Change Configuration Settings

1-6 DNAS Management

Commands to Display and Change Configuration Settings

Introduction

This section lists the type of commands that operate on the configuration settings

stored in VRAM and NVRAM.

The CHANGE and SET commands listed in the following chapters have an immediate

effect when you enter them. When you use the DEFINE command, however, the

changes are delayed:

• If you use the DEFINE command to make changes to a given port, these changes

take place the next time that a user logs in to the port.

• If you use the DEFINE command to make changes to access server settings, these

changes take effect the next time you initialize or plug in the server.

Reference

The

Network Access Server Command Reference

describes the syntax, range of values,

and defaults for all these types of commands. Use the

Command Reference

as a source

of supplementary information as you go through the examples and procedures in this

manual.

Types of Commands That Operate on Configuration Settings

The following illustration shows the types of commands stored in VRAM and

NVRAM:

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 535 536

Commenti su questo manuale

Nessun commento

HP Digital NetRider Manuale Utente Pagina 38

Commenti su questo manuale

Prodotti e manuali riguardandi Software HP Digital NetRider