HP Jetdirect 620n Fast Ethernet Print Server Manuale di Installazione Scaricare il pdf (Pagina 13)

Installation Procedures 13

ENWW

Verify Jetdirect Print Server

Operation

1. Print a Jetdirect Configuration page and check for status

messages.

In most printers, a Jetdirect Configuration page will

automatically print when you print a Printer Configuration

page. See your printer documentation for instructions.

In HP Designjet printers, Jetdirect configuration information

will be included on the Service Configuration print.

2. In the first section of the Jetdirect Configuration Page, look for

the status message “I/O CARD READY”. See

Figure 2-2.

This section of the configuration page also contains product-

specific information, such as:

Q HP Jetdirect product number

Q Firmware revision number

Q LAN Hardware (MAC) address

Q Manufacturing identification number

3. If I/O CARD READY appears, the card has been installed

successfully. Proceed to

If Required, Configure Jetdirect With

Your Network Settings.

If I/O CARD READY does not appear, check that you have:

Q Installed the print server correctly and properly connected the

print server to the network

Q Verified that the network is operating properly

You can turn the printer off and then on again to reinitialize the

print server and try again.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Nessun commento

HP Jetdirect 620n Fast Ethernet Print Server Manuale di Installazione Pagina 13