Both print cartridges must be correctly installed (with the green tab and blue tape
removed) for your HP PSC 500 to work. Make sure that the following things are done
Cartridges are pushed firmly into their slots.
Cartridge labels are facing toward you.
Both print-cartridge latches are down and locked.
Print-cartridge access door is closed and latched.
IN tray is pushed in completely.
Paper length adjuster is pushed firmly against the paper stack.
Step 4 — Connect the Printer Cable and Power Cords
Use the printer cable that was shipped with your unit. It is a special bi-directional,
parallel, IEEE 1284-compliant printer cable with a 1284-C connector that is necessary
for the proper functioning of your HP PSC 500. If you choose to buy a longer cable,
make sure it is an IEEE 1284-compliant parallel cable with a 1284-C connector.
Connecting the Printer Cable
Locate your printer cable.
Connect the printer cable to the HP PSC 500. Pinch the clasps at the back
of the cable as shown in the diagram. The cable connector is located on
the back of the unit, in the middle. Make sure the cable snaps into place.
WLSG.book Page 7 Thursday, March 9, 2000 2:26 PM
Commenti su questo manuale