HP Vectra XE320 Guida alla Risoluzione dei Problemi Scaricare il pdf (Pagina 24)

Upgrading and Replacing PC Hardware

3 Check that the jumpers on the rear of the new drive are set to CS (cable select) mode.

4 Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above.

5 Tighten the two screws that fasten the drive to the bay.

6 Connect the data and power cables, and for DVD or CD-ROM drives on Linux models, the audio cable.

• If this is the second device installed in the expansion bays, fit the data connector marked SLAVE.

• If this is the only device, fit the end CD connector marked MASTER.

7 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).

8 Reconnect the power cord.

audio cable (only

required for Linux

models)

1 2 ... 19 20 21 22 23 24 25 26 27 28

Nessun commento

HP Vectra XE320 Guida alla Risoluzione dei Problemi Pagina 24