HP NetServer LP 2000r Guida Utente Scaricare il pdf (Pagina 97)

Chapter 10 Configuring the HP Netserver

2. Use the right-arrow or left-arrow key to select Security from the menu bar.

As soon as it is selected, the selections for the Security menu appear as

shown below.

➢Power-On Password

➢Hardware Security

The arrowhead ➢ indicates there is a submenu to select from.

3. If necessary, use the arrow key to move to the Power-On Password menu

selection and press Enter.

The Power-On Password is highlighted by default when the Security menu

is selected.

The first line in the menu is, "Power-on password is [Set or Not Set]"

◊ If no password has been set, then "Not Set" will appear in the field. If

this is the case, then you can boot the Netserver without a password.

The Power-on password controls access to the Setup Utility and its

settings, but will not be in effect until you reboot the Netserver.

◊ If "Set" is in the field, then you can change the password or remove the

password, if you know the existing password. If you do not know the

existing password, then refer to "Resetting a Lost Password" in Chapter

12, "Troubleshooting."

NOTE You must set the Power-on Password to configure the HP

Netserver to boot with a password.

4. Press the Enter key to enter a new password or change the old one.

A pop-up menu appears titled, "Set Power-On Password." If no password

has been entered, the field "Enter new password: [ ]" is highlighted. If

a previous password has been entered, the field "Enter old password:

[ ]" is highlighted.

NOTE To leave the pop-up menu without entering a password, press

the Esc key at any time.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 135 136

Nessun commento

HP NetServer LP 2000r Guida Utente Pagina 97