HP Embedded Firewall Series Manuale Utente Scaricare il pdf (Pagina 10)

1 Installing and Connecting the NIC

1 Carefully insert the NIC in the empty PCI slot, as shown in the previous illustration.

Press firmly to ensure that the NIC is fully seated in the slot. Secure the NIC with the

screw if you removed one earlier.

2 Replace the computer cover and plug in the power cord. Do not turn on the power to

the computer.

3 Connect the cable.

3CR990B-97 NIC

Plug the RJ-45 connector on the twisted-pair network cable into the RJ-45 port on the

NIC backplate as shown in the following figure.

3CR990B-FX-97 NIC

Plug the network cable into the fiber port on the NIC backplate as shown in the

following figure.

4 Connect the other end of the network cable to an active network port.

The next step is to install the software. Go to the appropriate chapter for your

operating system.

NOTE: If your site network installation procedures require you to verify that

installed hardware is functional before you install software, run the

3C99XCFG.EXE DOS diagnostics program before installing the driver. For more

information, see “Using the 3Com DOS Configuration Program” on page 48.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 85 86

Nessun commento

HP Embedded Firewall Series Manuale Utente Pagina 10