HP 400 G1 Specifiche Scaricare il pdf (Pagina 119)

6. Press inward on the release lever at the rear of the device (1) and slide the device out of the rear

of the drive bay (2).

Installing a 3.5-inch device

1. Prepare the computer for disassembly (Preparation for disassembly on page 92).

2. Remove the access panel (

Access panel on page 93).

3. Remove the front bezel (

Front bezel on page 94). If you are installing a drive in a bay covered by

a bezel blank, remove the bezel blank. See

Bezel blanks on page 96 for more information.

4. Install 6-32 guide screws in the holes on each side of the device.

NOTE: HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to Drives

on page 105 for an illustration of the extra guide screws location.

When replacing a device, transfer the four 6-32 guide screws from the old device to the new one.

Drives

109

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 241 242

Nessun commento

HP 400 G1 Specifiche Pagina 119