Hp NonStop G-Series Manuale Utente Scaricare il pdf (Pagina 77)

Switch Command Interface (SWCI)

ServerNet Nomadic Disk (Release 2) User’s Guide—523968-001

6-7

Stopping SWCI

•

To start SWCI from a NonStop S-series server other than the one connected to

the switch module, at a TACL prompt, type:

1>RUN $SYSTEM.SYSTEM.SWCI \node.$SwitchModuleDevice

where:

\node

is the name of the remote node that switch module is connected to.

$switchmoduledevice

is the device name of the switch module.

Stopping SWCI

To stop SWCI , use the SWCI EXIT command. For example:

SWCI $NDSWA.#TERM> EXIT

SWCI Commands

SWCI executes each command as it is entered and displays results in the TACL

window from which SWCI was started (or to an alternate terminal or file if specified in

the TACL RUN command). SWCI continues to execute commands until it encounters

either an EXIT command or (if input is from a file) an end-of-file condition. Any invalid

command or other error condition detected by SWCI during command execution

results in an error message but does not terminate SWCI. SWCI commands have a

timeout value of one second, except the SELFTEST command, which has a timeout

value of three seconds. For examples on using SWCI commands for planned and

unplanned outages, see Section 5, Switchovers.

The SWCI commands are summarized in Table 6-1, and are categorized into three

types:

•

Action

•

Control

•

Status

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 147 148

Nessun commento

Hp NonStop G-Series Manuale Utente Pagina 77