Hp Netserver L Server series Manuale Utente Scaricare il pdf (Pagina 18)

Chapter 2 Controls, Indicators, and Ports

Power-Up and Power-Down Procedures

Power-Up Procedure

1. Make sure that the power interlock switch at the rear of the HP NetServer

is in the locked position, and that AC power is connected. When the

switch is locked, the slot through the middle of the switch is vertical. See

Figure 2-4.

◊ If the power interlock switch was unlocked, the system starts as soon

as you relock the switch if AC power is connected. Skip ahead to

step 3.

◊ If the power interlock switch was already locked, proceed to step 2.

NOTE The interlock switch locks the satellite chassis in place. As a

safety precaution, the server cannot power up unless this

switch is locked.

The HP NetServer

cannot start unless

the Power Interlock

Switch is in this position

Figure 2-4. Power Interlock Switch in Locked Position

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 146 147

Nessun commento

Hp Netserver L Server series Manuale Utente Pagina 18