Hp Netserver E Server series Manuale Utente Scaricare il pdf (Pagina 41)

5 Installing Additional Boards

Introduction

The system board in the HP NetServer E 800 provides up to seven PCI slots

(P1 through P7), with five 32-bits slots and two 64-bit slots.

Tested PCI Boards

For a list of tested PCI boards, check for compatibility in Configuration Assistant

on the Navigator CD-ROM or look for the Hardware Tested Products list for the

HP NetServer E 800 under the Service and Support topic for the specific NOS

used in the NetServer at HP’s web site:

http://www.hp.com/netserver/support/

CAUTION Some accessory board outputs may exceed U.S. National

Electrical code (NFPA 70) Class 2 or limited power source

limits and must use appropriate interconnecting cabling in

accordance with the National Electrical Code. (All

Hewlett-Packard boards comply with Class 2.)

Also refer to the Readme file and Configuration Advisor on your HP NetServer

Navigator CD-ROM. Refer to Chapter 8, "Configuring the HP NetServer," for

instructions.

Tools Required

The tools used to remove or add accessory boards in the NetServer include:

• Torx T-15 screwdriver

• ¼-inch flat blade screwdriver

• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit

includes a static-dissipating work surface, a chassis clip lead, and a wrist

strap.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 105 106

Nessun commento

Hp Netserver E Server series Manuale Utente Pagina 41